Sesame's system Installation process.
-
Absolutly necessary information before start
- For beeing detected each kit must be turned on before the central.
- To restart the central use the soft manner with the iSesame software (status tab).
- Please use the right power supply for each copmponent.
- Choose a place for the sbox where it is not "too far" from any Kit.
- Befor fixing definitively the sBox or a Kit, check it is reached by radio waves (obstacle distance...).
-
Verification/Configuration
- Choose the place you have Internet connection where you can put the Sesame Box.
- Connect all Sesame Kit's power.
- Connect the Internet cable of the Sesame Box, only then connect it's power.
- Launch Sesame's Application iSesame, in Preferences tab, enter the serial number of the sBox and the password you got from the seller.
- Check that all Kits are connected to the system (aftre starting the sBox, it can takes a few minutes for having all connection over the aire).
- Put each kit at the Check radio transmission perfect quality for all kits ( maximum ~ -50db). Find the best orientation of the Antenna if your signal is not strong enough. The sensitivity of the system is -90db for Serie I, -92db for Serie II and 102db for Serie II.
- Choose the place you have Internet connection where you can put the Sesame Box.
![]() |
![]() |
|
![]() |
Caractéristiques Sesame Serie II:
Relay number |
Thermometer |
Photosensor |
Extra input |
Radio range |
Camera |
Infra-red Sensor |
|
Box |
1 x 5 Amp |
0-120°C |
0to100% |
Yes |
|
|
|
K1 Kit |
1 x 10 Amp |
0-120°C |
0to100% |
Yes |
Upto-40 meters indoor uptoo 100 meters outdoor |
320x240 640x480 |
Very sensitive (7m range) |
K3 Kit |
2 x 10 Amp |
0-120°C |
0to 100% |
Yes |
// |
No |
No |